10 box for sale
Most Recent
Most Recent
All Results
31
KRB car trailer custom built May 2023 to suit Porsche, BMW or any other low profile and wide race/sports cars. Fully galvanized construction with one-piece fibreglass roof, and Alupanel walls, very little use and in new condition with the following features: WEIGHTS Tare mass 1,700kg ATM 3,500kg MEASUREMNETS Total Length 9m (includes drawbar) Internal Length 7.6m Total Height 2.420m Internal Height 1.920m Total Width 2.46m Internal Width 2.4m Width between wheel arch 2.020m GENERAL FEATURES
2
Brand new still in box as it arrived from the US WYO Billet Lock Up Unit Includes Trans Dump Valves for air shifting gearbox Was planned to work with a 5 speed Liberty Cost $24,000 to land here from the US and they are more now Save $4,000 and 6 months wait!!
5
8 months Rego, 2000 KG ATM, Built 2014. Suit small sports car, built for Lotus Elise, would also suit Mini, Clubman or similar size car. Could be used for as a toy carrier and has tie down points. (Lotus Elise S2 for sale in Race Car section) Fitted with override Disc Brakes, Pads just replaced. New spare tyre, 2x 40 ltr water tanks fitted, front locker box which fits 2 Marque frames, New Solar panel, New Battery, New Flood light, most trailer lights have been replaced. Remote control for
10
Price DROP, this is the cheapest fully enclosed two car carrier of its type in Australia. New build now is over $100k for the same set up. Two Car enclosed Trailer, fifth wheel. Originally built to carry two TA2 Cars, recently used for Two Corvettes, now excess to requirements. Very well set up with plenty of room and could easily be modifed to suit multiple purposes. ATM 7000kg Overall length pin to tailgate – 12m Overall external height (while on the leg not connected to the truck) – 2
3
Haltech 950 with complete harness New in box
14
For Sale An Albins AGB10 H Pattern transaxle gearbox with LS1 Bellhousing New In box. Has Not seen oil as its not been fitted to any vehicle, Never been out of the box since purchase. Bought Through Racetrans in NSW for an project but the overall Length is an issue for fitment into our particular vehicle. Within the gearbox you will find a pre installed Limited Slip Differential by the guys from albins and also provisions to mount an external oil cooler and pump to keep those oil temps low dur
3
Built by the legend himself Pip Barker New build never had fluids in it. Only been sat in a car for transport Should make 450+ hp S38 B36 - eng 86mm stroke 95.4mm bore 3688cc 11.4:1 compression Shotpeened resized rods with new rod bolts M1 Pro Car Valves 37.5 inlet, 32.5 exhaust S14 DTM 2.5ltr pistons Cosworth grind cams by Tighe Engineering (as per cam sheet) approx 316/320 S38B38 Head gasket Group A valve springs & retainers @ 75lb Will come with used carbon fibre air box and ultra light
25
9.5m fully enclosed, fully lined inside and out. Setup 4.45T rated axle and spring set. Tare 2.4T. Registered to 16/08/2024. MEASUREMENTS: • Main floor area (up to bedroom area) 5552mm. • Total width internally is 2335mm. • Between wheel arch is 1970mm. • Bedroom length is 1850mm. • Under bed storage is 650mm high. • Belly box measurements – 1200mm x 550mm x 360mm deep. • Front storage area is 500mm deep. • Internal ceiling height is 2000mm. • Overall height from the ground to rooftop is 2620mm
3
For Sale! Brand New 410 Inglis Sprintcar Engine Engine is brand new & built with current & latest parts. Engine is built & dynoed & has fuel system & ignition box. 700ft/lbs torque 900hp Phone for more details regarding parts & components. PRICE IS PLUS GST!
3
CORVETTE LOVERS LOVE THE NEW C8 CORVETTE Prestige Number Plates to suit C8 CORVETTE Brand New- never fitted. Fitting and transfer paperwork supplied complete with box. Can post.