25 items for sale
Most Recent
Most Recent
Keyword
Price
All Results
12
Roll CageLog Book
Owner motivated to sell Blown 1959 Corvette Montana Bros, New York Chassis 427 CN billet cross bolted block with Alan Johnson heads, top end. Fresh motor with 6 passes. 14/71 Fowler Superman 44 amp MSD mag, coil etc Recent front half build with all new Rims & Tyres, Brakes & suspension Mencer rear shocks with data New 3 speed Lenco with Bruno and Chance Billet convertor. Fully rewired, new fire system, belts and chutes. Comes with basic spares, Pro jacks. I do have an 2nd identical engine,
122
Roll Cage
What happens when you take an Audi A1, drop in a 2.0L TFSI turbocharged engine and build what is effectively a FWD S1 with an even higher output thanks to tuning house APR? A car that delivers a huge amount of driving thrills and “bang for buck” that is off the charts. Built by the team at Euro Car Electronics on the Sunshine Coast, this pocket rocket started life as an A1 however when the opportunity came about to install a low mileage 2.0L TSFI engine, ECU and wiring from a S1, the temptatio
9
Roll CageLog Book
69 Camaro Z28 Steel Body, Fibreglass Front Clip Doors & Boot. Awesome paint job inside & out. Race Built in USA, Imported to NZ 9 Years ago, has been drag racing in NZ for the last 8 seasons, with awesome results, personal best 8.1 @ 167mph on the quarter mile. Goes straight all day long, very consistent with its times. Awesome car to drive. Running Pat Musi 632 Race Engine, with only 16 runs on fresh rebuild, C16 Fuel, Trans 2 Stage Powerglide, Dedenbear Case with Neil Chance Bolt together Conv
10
Roll Cage
Audi TT-RS 5 Cylinder Race Car - Rare Manual 6Spd -AGI Half Cage -Sparco Circuit Seat -Audi Active adjustable damper system - Exhaust and Tune making good HP - 2 Piece Rotors and Pads F/R - 6x Forged wheels with Semi Slicks - very good mechanically with lots of upgrades, Maintainance records - Comes with original Seats if wanted -Trailer Available for extra $ - Open to swap/ trades - Can assist with transport and finance
8
Roll Cage
'78 Z28 race car SBC 350. Top loader 4 speed. 9" diff. Mini lite wheels. Just updated cams roll cage with bond roll bars. Have Pontiac front and other spare parts for body to be eligible for Australian trans am series. Believed to have NASCAR engine. Spare wheels available. Not a lot to do. Can complete work at buyers cost. Regretful sale.
6
Roll CageLog Book
Audi TCR RS3 LMS 2019 Model Fully Maintained by Track Tec Racing to full Audi Spec No Expense spared Never had Accident damage Race Winning Car Ideal 1hr Endurance car Comes with 8 rims & 12 tyres including new set of wets Car is located in Cromwell , Otago , NZ
9
Roll Cage
For sale is my 1969 Chevelle Malibu Pro-Street roller. 4 link, narrowed 9" rear, tubs, 10 point roll cage that extends to front subframe, Centerline Convo Pro wheels. Also included but not fitted is set of tubular front A-arms, a RHD power rack and Astra power steer pump with brackets. Body is excellent - painted Lamborghini Orange $30K paint job. No interior, engine or gearbox. Needs a killer engine to make this into a one-off special! I have too many projects and with ailing health, it's t
7
2006 Is7 427 GT Corvette Imported from Malaysia in 2013. Car ran in the Asia GT3 Series - Eligible for Historic Racing Harop 8 throttle body altronic ecu Emco sequential 6 speed box AP racing calipers and rotors The Drive Shaft Shop rear axles - 800 hp rated 2 x full sets of slicks and rims 1 x full set of wets and rims Many spares Car raced in QLD and NSW Production Sports and Classic Sport Sedans Very fast, strong car Won 2015 QLD Classic Sports Sedans Series $105,000 car and spares Fully enc
10 1
Roll CageLog Book
NSW Sports Sedan Championship winning car - 4 times in the last 10 years. The Camaro has been fully serviced since competing at the Gold Coast in the last Round of the 2023 National Sports Sedan Series and is ready to race. The Camaro has raced successfully and continuously in the NSW Sports Sedan State Championship and Bathurst Combined Sedans for the past 10 seasons, Bathurst Tin Tops, Island Magic and a number of seasons in the National Sports Sedan Series since 2013, including 2023 in wh
10
Roll CageLog Book
Best time 8.9 sec @ 153 mph , Art Morris chassis, Mustang 2 front tubular front end, Willwood disc brakes front and rear, QA1 front shocks coil overs. Ladder bar rear end, 9” diff strengthen by Aussie Diffs 3:5 ratio, 35 spin axles, alloy front carrier, Arco rear shocks and coil overs. Heavy duty tailshaft and uni joints. Motor Dart Big M tall block , very large Brodex heads, ARP Studs,JE Piston 2618, 16:1 comp,Total seal Rings, Jessel Rockers, Comp Cam full roller 11-721-9, ATI Super Dampener,
4
Roll CageLog Book
2000 Corvette Trans Am Carbon Fibre body. Best of everything, no expense spared. - 358 SB2, KB Carb - 180 degree headers - Holinger 5 speed (spare ratios), sequential, flat shift - Winters diff, 3 link or 4 link car - Air jacks, air gun, Paoli regulator, engine heater - Motec, GPS, transponder - Penske 3-way dampers - Brembo brakes, PFC rotors, Tilton clutch - All adjustable roll bars - 3 x sets of 16” BBS wheels - 2 x sets of 18” wheels - Huge spares package including radios, sprin
5
1969 Chevy Camaro top sportsman super sedan drag car 540 stack injected big block 2 speed power glide New tires brand new electrical right through car Brand new floor IHRA tech About 12 passes since engine was freshened Awesome consistent car to race
4 1
Imported into NZ last year with the following specification: • EVO-Kit since 2020 with a total mileage of 6.543 km • Overall km on Chassis: 26.290 km • Engine: 0 km • Gearbox: 4.700 km • Shocks: 2.120 km • All Bearings, Wishbones etc.: 6.543km • Driveshafts: 6.543km • Brake and Calipers: 6.543km • Shifting actuator and compressor: 10.918km • Fuelpumps and Filter new in 2021 Since this time, has done 2 days testing, and completed the Highlands 6 hour endurance - 4th in class, 5th overall, faste
7
Roll CageLog Book
**Price Drop Update** The Camaro has been fully serviced since competing at the Gold Coast and is ready to race. The Camaro has raced successfully and continuously in the NSW Sports Sedan State Championship and Bathurst Combined Sedans for the past 10 seasons, Bathurst Tin Tops, Island Magic and a number of seasons in the National Sports Sedan Series since 2013, including 2023 in which it finished 6th Outright for the season. It was built by Steve Vigurs of Steve's Toyshop, a well renowned s
8
Roll CageLog Book
Audi RS3 LMS TCR Chassis #144 - Highest Spec Audi of this model in Australia (4 in the country) - Sold new to Australia in 2019 - Previously driven by Garth Tander and JK Vernay (2019 QR Pole & Race win) - Every homologation update installed including Aero front bonnet catches, front, rear & side plastic windows (only Gen1 in Aus with these updates) - Ohlins Shock Absorbers installed, tuned and recently serviced by AD Racing Shocks ($25,000 new price, plus custom valving) - Multiple podiums in 2
32 1
Roll Cage
General: Full chrome moly tube chassis by Chris Alston in California. Glass front, steel doors and rear. New Tailgate, body stripped and repainted in custom pearl blue. Custom wing, wheelie bars, parachute. 20l alloy fuel cell, new rear mounted battery. Linelock and quick release steering wheel, 5 point harness, alloy ice box. Completely rewired throughout. Certified by both NZDRA and IHRA. All fabrication done by Raceworks in 2021. Engine: 427 LS7 built by Steve Morris in USA in 2021, approx 10
10
Roll CageLog Book
Gary Hansen RaceCraft built (USA) ex Pro Stock, complete roller, Koni electric shocks, Race Pack dash, race pack SC 1000 data logger, Lamb brakes, Ron Davies radiator, 40 spline Mark Williams axels, Weld Magnum wheels.. too much to list Has gone 7.22 @ 191 mph, will suit a wide variety of classes This car has less than 200 passes Please call for more information
6
Roll CageLog Book
New motor never been raced close ratio gear box with new clutch well engineered comes with 2 sets of rims 14" tidy car proven on track ex Gary Brown car and motor can be turned into a street car
20
Roll Cage
Time to go unfortunately, 1965 Chevy Belair, new build not quite finished. Set up for A Gas and or 1/8th mile. Diff - new Chevy 12bolt with Lenco spool 5.44 gears and Summers Bros axles and "C" clip eliminator kit new tailshaft. Wheels are 15x14.5 Centreline Pro stocks with 32in slicks, 15x5 frontrunners. New roll cage, tubs etc. Torana front end and steering with SPAX adjustable front shockers. Engine set up for Big Block Chev. Extractors to suit Big Block Chev, Fuel cell and spares ROLL
5
Roll Cage
This 72 Camaro is a project I started to build for the Australian Tans Am class. It has been caged and had the floor modified to suit the correct gearbox and where the muffler will sit. It has also had the pedal box master cylinders installed. The only thing missing is the 2 front guards. The car will also come with 2 brand new full quarter panels, a fiberglass bonnet, new race seat, pedal box, race fuel tank and brand new limited slip differential from the US. I have spent $25,000 to date