19 Motorsport Vehicles with Roll Cage for sale

Now available at Muscle Car Warehouse is one of the most iconic and most successful Chev Monza to grace Australian circuits was the wild-looking Bob Jane sports sedan. It was the last car Bob Jane raced in anger, before hanging up his helmet. The big-winged monster, built with a liberal dose of Aussie ingenuity, was also raced by fellow greats Peter Brock, Allan Grice, Dick Johnson, Bryan Thomson and Brad Jones. It all started way back in 1978 for Bob Jane and this Monza in the United States aft

Brand new motor 30k fully recond gear box 7k both one meeting old car well maintained as new body comes with 2 spare sets of wheels 5 gear sets and 7 sets of springs plus sway bar

Fully recon motor 18k fully severed gearbox 4.5k both 0km car well maintained body like new 2 spare sets of wheel 5 gear set 7 set of springs extra sway bar

'78 Z28 race car SBC 350. Top loader 4 speed. 9" diff. Mini lite wheels. Just updated cams roll cage with bond roll bars. Have Pontiac front and other spare parts for body to be eligible for Australian trans am series. Believed to have NASCAR engine. Spare wheels available. Not a lot to do. Can complete work at buyers cost. Regretful sale.

Mazda RX8 Multiple race winning car with all compliance parts sealed. Welded national roll cage, eligible for RX8 cup / Formula RX8 / production cars, Bathurst.

Competed in the 2023 National Trans Am Championship and finished inside the top 10. Professionally maintained by Dream Racing Australia between each event. New front and rear brakes (Pads & Rotors) Motec Tps sensor upgrade, Soild plate clutch upgrade, Larger oil cooler upgrade, Air box upgrade, Tail shaft with upgraded yoke and new uni-joints, Rebuilt diff, Recently serviced gearbox, Spare Front Bar, Spare Sway bar, 8 Rims (4 x slicks & 4 x wets) Leak down test performed after last round

2000 Corvette Trans Am Carbon Fibre body. Best of everything, no expense spared. - 358 SB2, KB Carb - 180 degree headers - Holinger 5 speed (spare ratios), sequential, flat shift - Winters diff, 3 link or 4 link car - Air jacks, air gun, Paoli regulator, engine heater - Motec, GPS, transponder - Penske 3-way dampers - Brembo brakes, PFC rotors, Tilton clutch - All adjustable roll bars - 3 x sets of 16” BBS wheels - 2 x sets of 18” wheels - Huge spares package including radios, sprin

1976 Fiat 131 Improved Production Logbook 6-point weld in roll cage Sparco seat and 6-point harness 2 litre twin cam built by tune masters. twin down draft Webber's 5 speed gearbox. 132 Diff 60 litre fuel cell. Spare engine, gearbox, diffs, panels and lots more Buy today, Race tomorrow. Located in NW Tasmania can assist with transport on Spirit of Tasmania call or text 0427 725 824

Rx8 with a honda k24a3 engine and tremec tr6060 gearbox. -honda k24a3 engine, bc double valve springs and retainers, 40 degree intake cam gear, k20 type r oil pump kit -custom engine mounts, gearbox cross member and diff mounts -custom steam pipe manifold, aeroflow gtx3071r turbo, 44mm wastgate, full 3 inch stainless exhaust -custom intake manifold, intercooler piping, catch can and other extensive fabrication -600x300 intercooler, alloy radiator, oil cooler -surge tank, walbro 460lph fuel pump

New motor never been raced close ratio gear box with new clutch well engineered comes with 2 sets of rims 14" tidy car proven on track ex Gary Brown car and motor can be turned into a street car

RX8 drift/track car project I have since given up on due to work commitments and a lack of time. I'd rather avoid parting it out. Includes: S1 RX8 chassis (stat write off, perfectly straight, no damage or rust that I've found). - cut out OEM driver seat mounting to fit race seat lower (havent patched hole yet). Custom shortened front uprights New LCAs New brake rotors New PMU pads New braided front lines New Custom valved coilovers New wheel bearings/hubs Wet NOS kit (10lb bottle) Other rando

This 72 Camaro is a project I started to build for the Australian Tans Am class. It has been caged and had the floor modified to suit the correct gearbox and where the muffler will sit. It has also had the pedal box master cylinders installed. The only thing missing is the 2 front guards. The car will also come with 2 brand new full quarter panels, a fiberglass bonnet, new race seat, pedal box, race fuel tank and brand new limited slip differential from the US. I have spent $25,000 to date

Selling new RX8 Bathurst 6 hr car, raced Bathurst 6 hr event. Built to the Production regulations for the Bathurst event. New AP brakes. Every component new and serviced. Spare package with spare new engine and gear box and wheels available. Over head Fuel rig with new hoses available. Perfect car to race reliably and cheaply in any 3E Production race or the Bathurst event.