45 Car, Bike or Kart for sale

Holden VZ SS Crewman L76 Gen 1V 6.0 Litre T56 6 Speed Manual 2006 Model Currently 520.8 RWHP ready for a retune to get the 650hp reliable its setup for if you wanted to. ENGINE WORK ProCharger D – 1SC Intercooled Centrifugal Supercharger Siemens / VDO 63lb per hour fuel injectors & custom fuel rail’s & fittings 044 fuel pump , surge tank & regulator , mounted underneath the car Pacemaker 4 into 1 ceramic coated extractors 2.5’ stainless steel twin system & high flow cats & dump tips Crow Cam 21

Brand new 383 Chev Roller engine Hillborn injection, powerglide. MSD ignition, 35 spline maxispool diff 4.33 diff gears, Harrop alloy diff carrier, deadenbear delaybox, chute, Convo Pro rims, the list goes on. Ground up build, bare metal respray, this car is a true steel body car with everything done and ready for its debut run down the 1/4mile. Receipts for engine and work total well over asking price. Further details contact Chris on 0409348441.

The GTR-X was a fascinating concept from the get-go; A fibreglass body, over a steel “ladder” chassis, which may seem exotic to an Australian market, but GM had been successfully using that technique with its iconic sports car, the Corvette, from 1953’s C1. Come 1969, the Corvette had evolved to the swoopy C3 guise, featuring independent suspension, four-wheel disc brakes and wild 427 L88 spec’ motors. Along that 16 year passage, the Corvette’s early mistakes became improvements and a smooth, fa

1980 vb sl/e commodore. 253 v8 automatic. Kept as original as possible. Always garaged barely driven. Has had brake system rebuilt and carby rebuilt a few years back. Has original purchase receipt also.

FOR SALE 2010 HOLDEN VE COMMODORE UTE SSV SET UP FOR STREET – TRACK CAR – DRAG RACE STREET REGISTERED WITH MOD PLATES QLD REGO 5-24 24500KM ENGINE 6.0 LITRE 495KW ON BACK WHEELS 1180 N.MT FORGE PISTONS ROD BOLTS CUSTOM CAM DOUBLE VALUE SPRING HARROP AIR INTAKE E85 INJECTORS E85 PUMP AND SURGE TANK 2300 HARROP SUPER CHARGER MANUAL 6 SPEED GTS S1 SEQUENTIAL SHIFTER CERAMIC CLUTCH WITH CUSTOM SLAVE CYLINDER 1000HP DRIVE SHAFT WITH 9” YOKE TRU TRACK DIFF CENTRE 4.11 GEARS 1000HP DRIVE SHAFT AXL

Vz commodore race car, this car is a newly built car everything on the vehicle is basically new I have only completed 1 event. Running gear: diff has been rebuilt with tru track centre with 3:7 gears, trans is standard, engine had full rebuild, honed block,rings,bearings reco heads with springs to match the new crow race cam and hand ported, trunnion upgrade, mellings oil pump, 92mm throttle body, sheet metal intake, ally radiator,moroso oil accumulator Ecu: standard ecu with stand alone wiri

Full description coming soon.

Exquisite 1965 Datsun Fairlady 1600 in immaculate condition with 14 years of meticulous restoration. This car is the predecessor to the 240Z, and is close to concourse condition. Luxuriously presented custom full grain leather, and custom french-polished wood grain dash. Original engine and running gear.

One of 2 x A9X’S used by Bob Morris to win the 1979 Australian Touring Car Championship (ATCC). Raced Bathurst 1000: 1977 and 1978. ATCC outright wins in 1978 and 1979. 3 owners from new, original cams logbook. Raced in period by multiple Le Mans 24Hr, Daytona 24hr, Spa 24Hr, Bathurst 1000, Indy 500 winners: DEREK BELL, DIETER QUESTER, JONNY RUTHERFORD, JANET GUTHRIE & of course; BOB MORRIS. Original, unrestored and magnificent. More pictures and information at: https://www.ecuriebowden.c

2010 Holden Statesman WE Sleeper Can be driven on open road Takes E85 only, set up for dragging 402 iron block with Borg Warner turbo Turbo 400 gear box Comes with tyres and rims to drag 14 psi, 868hp at the hubs, 10.8 sec quarter mile. Good condition, one owner only. Registered on road, genuine sleeper. $65,000 ono.

Holden LX Torana 4 Door Complete bare body Shell. All rust removed from body shell, new sills, A pillars, floor, boot, etc etc. Repair invoice available on request. All body deadener removed. Body has been stich welded. Wheel arches not done due was going fit race flairs. Body in bare metal and rust coated. Drivers door slight mark. Body ready for roll cage.

LS2 , 460RWH. 5 Speed Tremic, 9 inch . Power steering. Log booked. Good reliable car.

Statutory write off and fully repaired, We have photos of the damage which was the rear of the car,all receipts are available as well. Being a stat write off this vehicle can not be registered in Australia, can be used for track or export outside Australia. it is priced below our cost and needs to GO.

2012 Holden ve track ute cannot be registered. 5.7 LS1 vcm7 cam, ported heads, OTR cold air, trunuin upgrade, buckets, oil pump, timing chain, push rods, springs gaskets were all upgraded at same time was done about 1.5 year ago at KTMR performance. twin into single 3.5 exhaust sounds tuff,all braided oil lines, catch can, oil cooler, oil accumulator, powersteering cooler, coilovers, diff has a harrop full spool rated to handle 1000hp with 3.7 diff gears custom tailshaft (dount delete and bigg

Call Kevin 0418538961 Open to offers. Car is located in Melbourne LJ Torana 2 door Sports Sedan. Only used for sprint days at Sandown Raceway, Melbourne. Motor has only done 2 sprint days since rebuild by Hocking Engineering. Originally cost to build the engine was $30K, 350HP at the wheels Cams approved roll cage Log book 3.8 V6, dry sumped, injection, scat crank, argo rods, roller rockers, heads worked T5 Gearbox Weight is about 1100Kg Fibreglass doors, bonnet and boot lid. Lexen windows P

CAMS LOG BOOKED NO RUST 4 DOOR TORANA BUILT IN MIND OF THE GROUP C A9X APART OF HAVING OVER 500 HP BUILT WITH ALL NEW PARTS GROUND UP. TESTED AT QUEENS LAND RACE WAY 30 LAPS AT 7,000 TO 7.5000 OIL PRESSURE STAYED AT 50PSI 60 TO 70 ON START UP,CAR STOPPED CORNERED DROVE FANTASTIC BRAKE PADS ARE PMU USED HAS CLUB REGO,BUT IS A FULL 100% RACE CAR 308 RACE ENGINE COME RACING BILLET 3.55 CRANK,H BEAM 1.125 RODS,WISCO .020 PISTONS,CLIVE ROLLER CAM,T-BAR CPMP PRO ROLLER LIFTERS,OIL GALLERY DELIVERY

PRICE REDUCED AGAIN! Calibra 117k 2.5 v6 man red this car would make a good hillclimber or trackday car has alcon 4p mono front calipers dba club spec t3 330mm rotors alcon advantage 320mm rear rotors 2p calipers arp wheel studs 5x120pcd eibach coils kyb eurospec shocks poly bushes front&rear 17/7 alloy wheels fed rsr 215/40/17&235/40/17 fed 595 rear. Have 3.2 v6 from 2004 vectra with cat cams pac v/springs arp head bolts new balancer mtec billet flywheel with arp studs crossram intake off 3.0l