The Ultimate Daihatsu Rally Car Engine: Toyota 4AGE 20v Blacktop Kent Intake Cam Yoshi exhaust cam VVT deleted Eagle Rods and Pistons 12:1 compression Ported head with standard valves MRP Titanium retainers and valve springs EFI Hardware airbox 4” inlet with 100mm billet velocity stacks MRP Coil on plug conversion Custom 4-2-1 manifold Remote oil filter mount and Setrab Cooler Ross Performance race damper Reduction alternator and water pump pulleys Gearbox: Sadev ST75-14 5 Speed sequential to
Lc Torana race car cams log booked Engine, fully forged rb30/25 turbo have all receipts for engine build 35/82r turbo 38mm tial waste gate running mild boost and around 600hp R33 5sp gear box full built for race with brass button clutch Fuel system 1 x 048 lift pump 3 ltr swirl pot and 2 x 048 feed pumps to 1000cc injectors and spitfire coil packs all controlled by a Haltec pro platinum EMS on AV gas Rear end is a adjustable 10 bolt Borge Warner 38spline billet axels with full spool all bui
2003 WRX used for sprints rally & track days. Very reliable great entry level car. 200km on new clutch & gearbox. Near new front rotors, front and rear pads. 2nd set of rims & tyres. Brown Davis state level roll cage. Car is logged 3J. Maintenance & race prep by Ravage race works
2000 GC8 WRX Rolling Shell, was being built for Tarmac Rally and has a CAMS certified cage. Does not extend to the front towers at this stage, although the strut tops have had cromoly plates added over them and the A pillar to chassis rails have extra bracing. Has sill jack points also. The cage has double diagonal bracing throughout and gussets everywhere. Seat mounts are welded in also. Was a clear title undamaged road car and has been kept indoors since it was pulled off the road in 2014/15.
History: Competition history from 1977, mainly raced Amaroo & Oran Parks. Original & subsequent Logbooks come with the car. Restoration: Completed to 1983 spec for Certificate of Description purposes. Livery: Rapid Transport Mechanicals: 1380cc (new build by Ken Nelson 08/09/21) Block: Morris 1100s Crank: Steel Russell Head, CAM. All the best components I could afford for reliability & performance Pistons: Russell Eng
Road registered club car, just completed. This car was my daily driver up till 2012 when it was put into storage. Interior has been semi stripped (parts kept), motor rebuilt, new clutch, MCA suspension, belts, almost standard just made better.