5 Motorsport Vehicles for sale
Most Recent
Most Recent
Keyword
Price
Listing Type
All Results
15
2014 wrx manual rolling shell , no need to wait to have a cage built this is ready to build into a race car Has just had a national level tig welded roll cage fitted to the highest standard Includes fabricated alloy/ boot rear seat delete (18k in cage and fab) Custom seat base and momo race seat Full wiring harness , dash . All suspension factory and rear diff / drive shafts. Vehicle and was originally a write off , front damage lh end of the rail, has been checked out on jig and is stra
10
Roll Cage
Audi TT-RS 5 Cylinder Race Car - Rare Manual 6Spd -AGI Half Cage -Sparco Circuit Seat -Audi Active adjustable damper system - Exhaust and Tune making good HP - 2 Piece Rotors and Pads F/R - 6x Forged wheels with Semi Slicks - very good mechanically with lots of upgrades, Maintainance records - Comes with original Seats if wanted -Trailer Available for extra $ - Open to swap/ trades - Can assist with transport and finance
10
Roll CageLog Book
The vehicle is ready to race we have been competing in Improved production racing but have only taken out on track a few times due to circumstances we have decided to sell the vehicle. -The engine is only two races old -The Turbo and Intercooler have been up graded -6Pod brakes at front & 8 Pod brakes at the rear -3 Way adjustable suspension -Has been Dyno tunes with restrictor for improved production racing Loads of fun to drive around the track it's set up and ready to go.
28
Roll Cage
2002 Nissan Skyline R34 GTR MSPEC tuned by Full Stage Japan HKS STEGE III 2.8L STROKER KIT GT2530 x 2 EVC F-COM NEW GEAR BOX (GETRAG) CARBON TRIPLE PLATES CLUTCH IKEYA FORMULA LOWER ARM INJECTORS FUEL DELIVERY FUEL COLLECTOR TANK ARC RADIATOR FRONT INTER COOLER TRUST MUFFLER CARBON DOORS CARBON BONNET CARBON LID DRY CARBON REAR WING ENDRESS BRAKE CALIPER (MONO BLOCK) NISMO METER BOOST 1.2 550 ~ 580 PS BOOST 1.7 600 ~ 630 PS Only ran 300kms after the engine build Car is still in Japan $180,0
10
Roll Cage
2000 GC8 WRX Rolling Shell, was being built for Tarmac Rally and has a CAMS certified cage. Does not extend to the front towers at this stage, although the strut tops have had cromoly plates added over them and the A pillar to chassis rails have extra bracing. Has sill jack points also. The cage has double diagonal bracing throughout and gussets everywhere. Seat mounts are welded in also. Was a clear title undamaged road car and has been kept indoors since it was pulled off the road in 2014/15.