232 items for sale

Classic Mazda Rotary Rally Car. Spent nearly all of its life in a shed, has never needed rust repairs. Strong Mazda 12a 6port rotary motor, 4 speed, RX4 Manual Gearbox. Starts, Runs and drives as it should. Pops flames, bangs and crackles on trailing throttle. New Mazda LSD with 4.4 gears in a RX3 diff housing. Engineers Certificate, and Cams Logbook. Was on full Vic Reg, now on Club Plates. Never been a rust bucket but has been on a few Rallies. Check out the Photos as from part of the descrip

LSTV 8 ONE OFF FORD FGX XR8 Built September 2015 -1 of only 98 built “Smoke” 6 speed manuals. -Fitted with FORD PERFOMANCE ALUMINATOR SUPERCHARGED 5.0 LITRE CRATE ENGINE (Engine Number Stamped to match Original Build number and Vic Roads) (Original block/motor available as part of sale. Motor is stripped down and would need some work before re-assemble) - 457 KW (615 HP at rear wheels) 743 nm torque (35% more than limited edition “sprint” series) -9:5:1 Mahle forged low compression pistons

- Twin Steer Stretched Rigid - Room for 2 vehicles and equipment - Heating and cooling - Kitchen with drinking and grey water, microwave, plumbed sink, microwave ect - LED lighting throughout - Belly lockers - Engineering area with 4 screens - Generator - Workshop - Approx 900K kms

Hi, Selling my truck and transporter combination, the details of both are below: Scania R580 2005: - 1,036,244 Km - Semi Automatic - Truck has been serviced regularly (every 3 months) - Passed last HVIS inspection with no defects - Gearbox was rebuilt roughly 10 months ago - x8 rear tyres in good condition over 85% tread on tyres Transporter: - 40ft transporter - 1500kg rated rear lift - Split a/c system fitted

Originally was set up for Sprintcar but is currently set up for a Dirt Late Model, plenty of room so it will take any type of sedan or can be very easily converted back to take Sprintcar. Kubota Generator GL900 Billi Hot water unit 12/240 volt, dual battery system with inverter and solar power Airconditioners x 2 BAC drawer system 2 Winches Has a large storage area above Kitchenette and it can easily be converted to sleeping quarters 105,000 KLMs NSW Rego until September $230,000 For furth

2007 BMW Z4 M absolutely immaculate. Compliance plate Dec06. 6 Speed manual Don't settle for basic blue! Grab the hero colour - Imola Red 89,000 kms Full service history and books Last service was yesterday 10 May 2024 we have receipt. This is a VERY RARE AND VERY COLLECTIBLE CAR. One of only 103 Australian cars, with under 2000 RHD made world wide between 2006 - 2008 and only 4,000 overall. This compares to around 56,000 of the common and 100kg heavier E46 M3 coupes ... The S54 motor was

FOR SALE NEVCO SINGLE AXLE EZY APROACH CAR TRAILER ATM-3200KG TARE-1080KG CAPACITY= 2120KG Bed Lenghth 5.4m Bed width= 1930 INCLUDED TRAILER STAINLESS STEEL PIT TROLLERY WITH JERRY CAN HOLDER WINCH 4.5T LOW PROFILE RAMPS INBUILT BATTERY CHARGER Tie Down straps

White dual axle trailer with high load capacity, (trailer 750Kg, carrying capacity 2050Kg). Electric brakes, electric winch, load ramps, toolbox. Overall 6x2.5m, inside wheel arches 4.5x2m.

Low 26855ks NEW Clutch Ring gear Fuel pump Disc pads Roll cage ( needs some modification to fit ) Discs machined, bearings inspected and repacked Rear brakes inspected and freshened Carburetors rebuilt by Claud ( $800 ) Previous owner replaced fuel lines with braided. Previous owner had it on club registration Good tyres FULL DISCLOSURE Holes in front of screen for wipers ect covered by tape, see photo A couple of times the clutch “dragged “ I suspect the mechanic didn’t grease the spli

I bought this truck as was, It was going to be the new Kumho Motorsport truck. (And my race truck on the side). F$%#kin TCR. It is set up to transport 1 car with a separate Kitchen/workshop area up front. It has room for a medium size sedan with the divider wall in but I have also seen this truck carry V8 Supercars. It is well set up with extender ramps to carry up to a 2500kg sedan. Since purchase, I have spent over $20K bringing it back to A1 spec. This spend included all the mechanical updat

2011 Galvanised chassis Ali top Re door and side door Hydraulic tipping with ramps Electric brakes and front winch Dec, size 4.5 x 2 m height 2m Twin axle good tyres

This was originally built in 2007 and fully refurbished and upgraded in 2021, including a 150x50mm A Frame. Break back and beaver tail Roller rocker suspension Checker plate sides and A frame Redarc breakaway system on both axels 2m custom heavy duty aluminium ramps stored under on Teflon skids Tare: 960kg GVM: 2,920kg NSW Registration until 23.2.2025 Total length: 6.5m Deck Length: 4.5m Width between guards: 2m Total width: 2.5m Height of box: 2.2m Box dimensions: 650mm H, 750m

- 2015 Build - Auto Transmission - Immaculate 8.5mtr x 2.49mtr Beavertail Tray - Heavy Duty bi-fold ramps w. Electric power pack - Previous use Prestige car transport - Can take LOW height vehicles - BIG 7.2 ton Payload, electric winch on deck - Suit Motorsport, car, trailer, or machinery haulage - Air to rear suit large trailer, Tow Ball, Anderson plug - Mainly Interstate KM's - Large toolbox at front can fit 8x 17-18' wheels, 2400 x 780 x 700, Belly Locker on side - Tidy inside & out of cab -

## DEPOSIT NOW TAKEN## Pristine condition 2018 Futura lowering trailer which has always been stored inside. Factory lockable tyre rack, rock guard, car winch, spare wheel (mounted underneath), tie down straps, break away protection. Tyres near new, new battery & trailer is also fitted with an additional lockable checker plate tool / storage box. Due to construction & light weight (600kgs tare, 2500kg gross), most cars can be carried without he need for larger 4WD type vehicles. (please check you